Motor Mount

Remember to use Thread Lock on all Bolts and Set Screws.
 
1)Install the Prop Saver onto the motor shaft

2)Cut the motor shaft down  so only 1/2in is sticking out of the prop saver

3)Use small bolts included to install the motor mount to the plastic firewall
4)On the top bolt place a small washer to give the motor slight down thrust.

5)Finish up the installation with the two bottom bolts
6)Trim off the extra plastic firewall
 
 
7)Cut a 4 in piece of 3/8 x 3/8 wood
8)Place the plastic firewall on the wood and measure back 3/4in. This is where the Lead Edge will be.

9)Drill holes in the plastic firewall and wood for the mounting bolt and screw.